Solid-state-logic AWS V4 Manual do Utilizador descarregar pdf (Página 40)

15. Assigning the AWS IP address

By default, AWS uses a fixed IP address of 192.168.1.2. Dynamic (DHCP) address allocation can be selected via the

SSL/NET menu. The currently assigned address is also shown in the SSL/NET menu. If your AWS is connected to the

computer via a network switch or router which contains a DHCP server, it should be assigned a DHCP IP address;

otherwise the fixed option should be used. Once you have altered the IP mode, you need to restart your AWS for

the change to take effect. A software restart option is available in the SSL/SETUP menu.

An alternative fixed IP address can be set using the console diagnostic port. This should not be necessary in most

installations. You will need a PC or Mac running terminal emulator software. Connect your computers serial port to

the rear of the console using a 9 way ‘D’ type extension cable. The pin out for the console’s 9 way ‘D’ type serial

connector is shown below:

PPiinn DDeessccrriippttiioonn

1 Carrier (Linked to 0V)

2 TX

3 RX

4 DTR (Linked to DSR)

5 0V

6 DSR (Linked to DTR)

7 RTS (Linked to CTS)

8 CTS (Linked to RTS)

9 RI (Linked to 0V)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45

Sem comentários

Solid-state-logic AWS V4 Manual do Utilizador Página 40